Rate this post

DES-5221 Practice Exam Tests Latest Updated on Aug-2022

Pass DES-5221 Exam in First Attempt Guaranteed Dumps!

Dell EMC DES-5221 Exam Syllabus Topics:

Topic Details Weights
Data Center Technologies and Protocols – Virtual Link Trunking – Describe the components that makeup a VLT configuration; Configure and validate VLTs; troubleshoot basic VLT configuration issues
– Virtual Router Redundancy Protocol – describe the basic operation of VRRP; identify the components of VRRP; describe VRRP Priorities; compare Pre-empt and no Pre-empt; configure VRRP on switches configured for VLT
– Uplink Failure Detection – describe the components and operation of UFD; identify the differences between Active/Active and Active/Standby; configure and verify UFD
– Virtual Routing and Forwarding – describe the operations and use cases for (VRF); configure and validate VRF
– Quality of Service – Describe the basic operation of QoS; Describe how QoS identifies and marks traffic; identify the characteristics of QoS; identify QoS protocols and their uses; configure QoS
– Multicast – Explain in depth the concepts relating to IP Multicast technology; compare IGMP and PIM use cases; identify the steps required to configure multicasting into an existing multicast environment
29.6%
Discovery Protocols – Describe the characteristics of discovery protocols; describe uses cases for using discovery protocols; explain how to configure and validate. Configure discovery protocols; interpret LLDP outputs – Basic Routing – Configure IPv4 on an interface; identify when to utilize a gateway as a last resort; configure and modify static routes; test inter-VLAN routing
– Open Shortest Path First – describe OSPF operation, and core components; configure and validate OSPF using; interpret OSPF show commands; describe the operations and use cases for ECMP; test inter-VLAN routing
– Border Gateway Protocol – Explain operations of BGP;
– identify design best practices when configuring BGP in a leaf/spine environment; configure and validate BGP; Describe the operations and use cases for ECMP; configure and validate ECMP
– Policy-Based Routing – Describe the basic operation of PBR; identify PBR use cases; configure and validate PBR
30.7%
Networks – The Basics – Identify common data center topologies, protocols, and topologies; describe the Dell EMC data center switch portfolio
– Basic switch configuration: Identify the normal boot process of a S and Z-Series switch running OS 10. List the first-time switch setup requirements. Perform the steps for upgrading switch firmware in OS 10.
– Access Control Lists: Explain the purpose of access control; apply appropriate commands to deny or permit IP connectivity; complete the required configuration to permit host access control; determine why particular computers are being blocked from accessing a server
– AAA Security: Explain the purpose of AAA security; describe AAA process, core components and their function; configure local and RADIUS authentication
– Dynamic Host Configuration Protocol: DHCP’s basic operation; Explain the role of the DHCP Relay; configure DHCP in OS10; identify the options to secure DHCP from attacks
19.6%
Layer-2 Technologies and Protocols – Virtual Lans – Identify the characteristics of a VLAN; explain the differences between tagged and untagged frames; configure VLAN trunking; configure VLAN Port membership; verify trunking and Port Membership; troubleshoot VLANs
– Spanning-tree Protocol – Identify the operations and use cases for STP; Configure and validate RSTP/MSTP/RSTP-PV; Manipulate spanning tree root bridge and port cost configurations
– Link Aggregation Groups – Identify the operations and use cases for LAGs; configure, verify, and trouble shoot static LAGs; configure, verify, and troubleshoot dynamic LAGs
– Discovery Protocols – Describe the characteristics of discovery protocols; describe uses cases for using discovery protocols; explain how to configure and validate. Configure discovery protocols; interpret LLDP outputs
20.1%

 

NO.14 Using the MAC 8c-ec-4b-5b-61-9d, what is a valid EUI-64 link local address?

 
 
 
 

NO.15 An administrator is implementing VLT in OS10. What type of port-channel must they configure for the VLTi?

 
 
 
 

NO.16 Match the QoS terms to their descriptions.

NO.17 In the OS10 CLI what does Ctrl+A do?

 
 
 
 

NO.18

Refer to the exhibit.
A default route exists on OS10-C that points all internet traffic towards 10.0.13.3 on OS10-B. A network administrator needs to re-route internet traffic only sourced from Host-1 to 10.0.12.2 on OS10-A instead. What feature can the administrator implement to accomplish this goal?

 
 
 
 

NO.19 When the show ip bgp neighbors command is issued, which BGP state reflects a successfully created adjacency with another BGP peer?

 
 
 
 

NO.20 Refer to the exhibit.

Which configuration will allow S1 to ping S2’s Lo0 address?

 
 
 
 

NO.21 There is a spanning tree mismatch at the global level. PVST+ is configured on a VLT peer. All VLT port channels go down on both VLT peers. A syslog error message is generated. What is the correct action to resolve the issue?

 
 
 
 

NO.22 How does a DHCP Client make a request to a DHCP server following an offer?

 
 
 
 

NO.23

Refer to the exhibit.
Where is the rendezvous point for the group 239.255.255.250?

 
 
 
 

NO.24 What is a feature of virtual routing and forwarding (VRF)?

 
 
 
 

NO.25 At which layer does LLDP operate?

 
 
 
 

NO.26 Refer to the exhibit.

Where is the rendezvous point for the group 239.255.255.250?

 
 
 
 

NO.27 You have been asked to examine a BGP configuration for a co-worker who is having difficulty establishing BGP peering. The address shown is that of the neighbor’s Lo0 interface. Given the configuration shown, what would be your recommendation?
S3(config-router-bgp-65042)# neighbor 192.168.32.1
S3(config-router-neighbor)# remote-as 65042

 
 
 
 

NO.28 A network administrator enters the BGP command neighbor 10.0.2.1. The BGP router does NOT have any route to the 10.0.2.0 network. What will happen?

 
 
 
 

NO.29

Refer to the exhibit.
Which configuration will allow S1 to ping S2’s Lo0 address?

 
 
 
 

Understanding functional and technical aspects of Specialist – Implementation Engineer, Data Center Networking Version 1.0 Layer-2 Technologies and Protocols

The following will be discussed in DELL DES-5221 exam dumps:

  • Identify the operations and use cases for STP; Configure and validate RSTP/MSTP/RSTP-PV; Manipulate spanning tree root bridge and port cost configurations
  • Virtual Lans – Identify the characteristics of a VLAN; explain the differences between tagged and untagged frames; configure VLAN trunking; configure VLAN Port membership; verify trunking and Port Membership; troubleshoot VLANs
  • Link Aggregation Groups
  • Spanning-tree Protocol
  • Identify the operations and use cases for LAGs; configure, verify, and trouble shoot static LAGs; configure, verify, and troubleshoot dynamic LAGs

 

DCS-IE Free Certification Exam Material from BraindumpsIT with 60 Questions: https://www.braindumpsit.com/DES-5221_real-exam.html

         

Leave a comment

Your email address will not be published. Required fields are marked *

Enter the text from the image below