(2022) PASS H12-811 exam with Huawei H12-811 Real Exam Questions [Q188-Q202] : IT Certification Exam Braindumps : http://blog.braindumpsit.com

QUESTION 188
The origin of SDN is the separation of transfer and control. The separation of transfer and control is a way to realize SDN, not the essence.

True

False

QUESTION 189
The IP addresses of the VLANIF interfaces of the same switch cannot be the same.

True

False

QUESTION 190
The role of the collaboration layer in the SDN architecture is to complete job deployment based on user intentions. OpenStack belongs to the business collaboration layer.

TURE

FALSE

QUESTION 191
The Layer 2 switch is a data link layer device, which can identify the MAC address information in the data frame, forward data according to the MAC address, and record these MAC addresses and corresponding port information in its own MAC address table.

True

False

QUESTION 192
Which statement is wrong about the ARP message?

ARP reply packets are sent unicast

Any link layer protocol requires ARP messages to assist in obtaining data link layer identification

ARP packets cannot be forwarded to other broadcast domains

ARP request message is sent by broadcast

QUESTION 193
Which of the following types of addresses is not included in IPv6 addresses?

Anycast address

Broadcast address

Unicast address

Multicast address

QUESTION 194
Which statement about SNMP protocol is correct?

SNMP uses UDP as the transport layer protocol

SNMP uses ICMP as the network layer protocol

SNMP protocol uses multicast to send management messages

The SNMP protocol only supports the sending of flash management messages on the Ethernet link

QUESTION 195
The load sharing mode at both ends of the Eth-Trunk can be inconsistent.

TRUE

FALSE

QUESTION 196
When the Access type port sends a message, it will ().

Send messages with tag

Strip the VLAN information of the message, and then send it out

Type the PVID information of this port, and then send it out

Add the ZLAN message of the message, and then send it out

QUESTION 197
The correct description of the information as shown in the figure is ().
[R1]display interface go/0/o
GigabitEthernet0/0/0 current state: Administratively DOWN Line protocol current state: DOWN

The GigabitEthernet 0/0/0 interface was manually closed by the administrator

GigabitEthernet 0/0/0 interface does not enable dynamic routing protocol

The GigabitEthernet 0/0/0 interface is not configured with an IP address

GigabitEthernet 0/0/0 interface is connected to a wrong cable

QUESTION 198
The administrator wants to configure a hundred IP address on the G0/0/0 interface of the router, then which of the following addresses is correct?

192.168.10.112/30

237.6.1.2/24

127.3.1.4/28

145.4.2.55/26

QUESTION 199
What is the full name of the general routing platform VRP?

Versatile Redundancy Platform

Versatile Routing Protocol

Versatile Routing Platform

Virtual Routing Platform

QUESTION 200
FIT AP can work independently without relying on AC.

True

False

QUESTION 201
What is the role of the command port trunk allow pass vlan all?

If the port default vlan 3 command is configured for the connected remote device, VLAN 3 cannot communicate between the two devices

All VLAN data frames are allowed to pass through this port

The connected peer device can dynamically determine which VLAN IDs are allowed to pass

The opposite port connected to the port must be configured with port trunk permit vlan all

QUESTION 202
What is the destination IP address of the DHCP DISCOER message?

127.0.0.1

224.0.0.1

224.0.0.2

255.255.255.255