This page was exported from IT Certification Exam Braindumps [ http://blog.braindumpsit.com ] Export date:Sat Apr 5 1:20:05 2025 / +0000 GMT ___________________________________________________ Title: [Nov 15, 2022] Get New NSE7_SDW-6.4 Practice Test Questions Answers [Q20-Q40] --------------------------------------------------- [Nov 15, 2022] Get New NSE7_SDW-6.4 Practice Test Questions Answers NSE7_SDW-6.4 Dumps and Exam Test Engine QUESTION 20Which statement defines how a per-IP traffic shaper of 10 Mbps is applied to the entire network?  FortiGate allocates each IP address a maximum 10 Mbps of bandwidth.  Each IP is guaranteed a minimum 10 Mbps of bandwidth  A single user uses the allocated bandwidth divided by total number of users.  The 10 Mbps bandwidth is shared equally among the IP addresses. QUESTION 21Which two statements describe how IPsec phase 1 main mode is different from aggressive mode when performing IKE negotiation? (Choose two )  A peer ID is included in the first packet from the initiator, along with suggested security policies.  XAuth is enabled as an additional level of authentication, which requires a username and password.  A total of six packets are exchanged between an initiator and a responder instead of three packets.  The use of Diffie Hellman keys is limited by the responder and needs initiator acceptance. QUESTION 22Refer to the exhibit.Multiple IPsec VPNs are formed between two hub-and-spokes groups, and site-to-site between Hub 1 and Hub 2 The administrator configured ADVPN on the dual regions topologyWhich two statements are correct if a user in Toronto sends traffic to London? (Choose two )  Toronto needs to establish a site-to-site tunnel with Hub 2 to bypass Hub 1.  The first packets from Toronto to London are routed through Hub 1 then to Hub 2.  Traffic from Toronto to London triggers the dynamic negotiation of a direct site-to-site VPN  London generates an IKE information message that contains the Toronto public IP address QUESTION 23Refer to exhibits.Exhibit A.Exhibit B.Exhibit A, which shows the SD-WAN performance SLA and exhibit B shows the health of the participating SD-WAN members.Based on the exhibits, which statement is correct?  The dead member interface stays unavailable until an administrator manually brings the interface back.  The SLA state of port2 has exceeded three consecutive unanswered requests from the SLA server.  Port2 needs to wait 500 milliseconds to change the status from alive to dead.  Check interval is the time to wait before a packet sent by a member interface considered as lost. QUESTION 24Refer to the exhibit.Based on the exhibit, which statement about FortiGate re-evaluating traffic is true?  The type of traffic defined and allowed on firewall policy ID 1 is UDP.  FortiGate has terminated the session after a change on policy ID 1.  Changes have been made on firewall policy ID 1 on FortiGate.  Firewall policy ID 1 has source NAT disabled. QUESTION 25Refer to exhibitsExhibit A shows the system interface with the static routes and exhibit B shows the firewall policies on the managed FortiGate Based on the FortiGate configuration shown in the exhibits, what are two issues you might encounter when creating an SD-WAN interface on port1 and port2? {Choose two )  Member interfaces that are administratively down  Member interface that have IP address of 0.0.0.0/0.0.0.0  Member interfaces that are physical interfaces as well as VLAN aggregate, and iPsec interfaces  Member interfaces that are referenced by any other configuration element QUESTION 26Refer to the exhibit.Based on output shown in the exhibit, which two commands can be used by SD-WAN rules? (Choose two.)  set cost 15.  set source 100.64.1.1.  set priority 10.  set load-balance-mode source-ip-based. QUESTION 27Refer to the exhibit.FortiGate has multiple dial-up VPN interfaces incoming on portl that match only FIRSTJVPN.Which two configuration changes must be made to both IPsecVPN interfaces to allow incoming connections to match all possible IPsec dial-up interfaces? (Choose two )  Configure a unique peer ID for each dial-up VPN interface  Use unique Diffie Hellman groups on each VPN interface  Use different proposals are used between the interfaces.  Configure the IKE mode to be aggressive mode QUESTION 28Which diagnostic command you can use to show interface-specific SLA logs for the last 10 minutes?  diagnose sys virtual-wan-link health-check  diagnose sys virtual-wan-link log  diagnose sys virtual-wan-link sla-lcg  diagnose sys virtual-wan-link intf-sla-log QUESTION 29Refer to exhibits.Exhibit A.Exhibit B.Exhibit A shows the SD-WAN performance SLA and exhibit B shows the SO-WAN interface and the static routes configuration.Port1 and port2 are member interfaces of the SD-WAN, and port2 becomes a dead member after reaching the failure thresholds Which statement about the dead member is correct?  Subnets 100 .64-1.0/23 and 172 . 20 . 0. 0/16 are reachable only through port1  SD-WAN interface becomes disabled and port1 becomes the WAN interface  Dead members require manual administrator access to bring them back alive  Port2 might become alive when a single response is received from an SLA server QUESTION 30An administrator is troubleshooting VoIP quality issues that occur when calling external phone numbers. The SD-WAN interface on the edge FortiGate is configured with the default settings, and is using two upstream links. One link has random jitter and latency issues, and is based on a wireless connection.Which two actions must the administrator apply simultaneously on the edge FortiGate to improve VoIP quality using SD-WAN rules? (Choose two.)  Select the corresponding SD-WAN balancing strategy in the SD-WAN rule.  Choose the suitable interface based on the interface cost and weight.  Use the performance SLA targets to detect latency and jitter instantly.  Place the troublesome link at the top of the interface preference list.  Configure an SD-WAN rule to load balance all traffic without VoIP. QUESTION 31Refer to exhibits.Exhibit A shows the performance SLA exhibit B shows the SD-WAN diagnostics output.Based on the exhibits, which statement is correct?  Port1 became dead because no traffic was offload through the egress of port1.  SD-WAN member interfaces are affected by the SLA state of the inactive interface.  Both SD-WAN member interfaces have used separate SLA targets.  The SLA state of port1 is dead after five unanswered requests by the SLA servers. QUESTION 32What are two benefits of using FortiManager to organize and manage the network for a group of FortiGate devices? (Choose two )  It simplifies the deployment and administration of SD-WAN on managed FortiGate devices.  It improves SD-WAN performance on the managed FortiGate devices.  It sends probe signals as health checks to the beacon servers on behalf of FortiGate.  It acts as a policy compliance entity to review all managed FortiGate devices.  It reduces WAN usage on FortiGate devices by acting as a local FortiGuard server. QUESTION 33Which two statements describe how IPsec phase 1 main mode is different from aggressive mode when performing IKE negotiation? (Choose two )  A peer ID is included in the first packet from the initiator, along with suggested security policies  The use of Diffie Hellman keys is limited by the responderand needs initiator acceptance  XAuth is enabled as an additional level of authentication which requires a username and password  A total of six packets are exchanged between an initiator and a responder instead of three packets. QUESTION 34In the default SD-WAN minimum configuration, which two statements are correct when traffic matches the default implicit SD-WAN rule? (Choose two )  Traffic has matched none of the FortiGate policy routes.  Matched traffic failed RPF and was caught by the rule.  The FIB lookup resolved interface was the SD-WAN interface.  An absolute SD-WAN rule was defined and matched traffic. QUESTION 35Which CLI command do you use to perform real-time troubleshooting for ADVPN on either a hub or a spoke FortiGate?  diagnose sys virtual-wan-link service  get router info routing-table  diagnose debug application ike  get ipsec tunnel list QUESTION 36Refer to the exhibit.What must you configure to enable ADVPN?  On the hub VPN, only the device needs additional phase one sett  ADVPN should only be enabled on unmanaged FortiGate devices.  Each VPN device has a unique pre-shared key configured separately on phase one  The protected subnets should be set to address object to all (0.0 .0. 0/0). QUESTION 37Which two statements reflect the benefits of implementing the ADVPN solution to replace conventional VPN topologies? (Choose two )  It dynamically assigns cost and weight between the hub and the spokes, based on the physical distance  It creates redundant tunnels between hub-and-spokes, in case failure takes place on the primary links  It ensures that spoke-to-spoke traffic no longer needs to flow through the tunnels through the hub  It provides direct connectivity between all sites by creating on-demand tunnels between spokes. QUESTION 38Refer to exhibits.Exhibit A shows the source NAT global setting and exhibit B shows the routing table on FortiGate.Based on the exhibits, which two statements about increasing the port2 interface priority to 20 are true? (Choose two.)  All the existing sessions that do not use SNAT will be flushed and routed through port1.  All the existing sessions will continue to use port2, and new sessions will use port1.  All the existing sessions using SNAT will be flushed and routed through port1.  All the existing sessions will be blocked from using port1 and port2. QUESTION 39Which statement about using BGP routes in SD-WAN is true?  Adding static routes must be enabled on all ADVPN interfaces.  VPN topologies must be form using only BGP dynamic routing with SD-WAN  Learned routes can be used as dynamic destinations in SD-WAN rules  Dynamic routing protocols can be used only with non-encrypted traffic QUESTION 40Refer to exhibits.Exhibit A shows the performance SLA exhibit B shows the SD-WAN diagnostics output.Based on the exhibits, which statement is correct?  Both SD-WAN member interfaces have used separate SLA targets.  The SLA state of port1 is dead after five unanswered requests by the SLA servers.  Port1 became dead 1ecause no traffic was offload through the egress of port1.  SD-WAN member interfaces are affected by the SLA state of the inactive interface  Loading … Fortinet NSE7_SDW-6.4 Exam Syllabus Topics: TopicDetailsTopic 1Centrally manage an SD-WAN infrastructure from FortiManager Configure basic SD-WAN setupTopic 2Configure SD-WAN routing SD-WAN troubleshootingTopic 3Configure SD-WAN rules Troubleshoot VPN and ADVPN   2022 New BraindumpsIT NSE7_SDW-6.4 PDF Recently Updated Questions: https://www.braindumpsit.com/NSE7_SDW-6.4_real-exam.html --------------------------------------------------- Images: https://blog.braindumpsit.com/wp-content/plugins/watu/loading.gif https://blog.braindumpsit.com/wp-content/plugins/watu/loading.gif --------------------------------------------------- --------------------------------------------------- Post date: 2022-11-15 12:30:15 Post date GMT: 2022-11-15 12:30:15 Post modified date: 2022-11-15 12:30:15 Post modified date GMT: 2022-11-15 12:30:15