This page was exported from IT Certification Exam Braindumps [ http://blog.braindumpsit.com ] Export date:Sat Apr 12 19:30:38 2025 / +0000 GMT ___________________________________________________ Title: Last NSE7_SDW-7.0 practice test reviews Practice Test Fortinet dumps [Q18-Q35] --------------------------------------------------- Last NSE7_SDW-7.0 practice test reviews: Practice Test Fortinet dumps Try NSE7_SDW-7.0 Free Now! Real Exam Question Answers Updated [Oct 31, 2023] NO.18 Refer to the exhibit.An administrator is troubleshooting SD-WAN on FortiGate. A device behind branch1_fgt generates traffic to the 10.0.0.0/8 network. The administrator expects the traffic to match SD-WAN rule ID 1 and be routed over T_INET_0_0. However, the traffic is routed over T_INET_1_0.Based on the output shown in the exhibit, which two reasons can cause the observed behavior? (Choose two.)  The traffic matches a regular policy route configured with T_INET_1_0 as the outgoing device.  T_INET_1_0 has a lower route priority value (higher priority) than T_INET_0_0.  T_INET_0_0 does not have a valid route to the destination.  T_INET_1_0 has a higher member configuration priority than T_INET_0_0. NO.19 Which statement is correct about SD-WAN and ADVPN?  Routes for ADVPN shortcuts must be manually configured.  SD-WAN can steer traffic to ADVPN shortcuts, established over IPsec overlays, configured as SD-WAN members.  SD-WAN does not monitor the health and performance of ADVPN shortcuts.  You must use IKEv2 on IPsec tunnels. NO.20 Refer to the exhibits.Exhibit A –Exhibit B –Exhibit A shows a site-to-site topology between two FortiGate devices: branch1_fgt and dc1_fgt. Exhibit B shows the system global and system settings configuration on dc1_fgt.When branch1_client establishes a connection to dc1_host, the administrator observes that, on dc1_fgt, the reply traffic is routed over T_INET_0_0, even though T_INET_1_0 is the preferredmember in the matching SD-WAN rule.Based on the information shown in the exhibits, what configuration change must be made on dc1_fgt so dc1_fgt routes the reply traffic over T_INET_1_0?  Enable auxiliary-session under config system settings.  Disable tp-session-without-syn under config system settings.  Enable snat-route-change under config system global.  Disable allow-subnet-overlap under config system settings. ExplanationControlling return path with auxiliary session When multiple incoming or outgoing interfaces are used in ECMP or for load balancing, changes to routing, incoming, or return traffic interfaces impacts how an existing sessions handles the traffic. Auxiliary sessions can be used to handle these changes to traffic patterns.https://docs.fortinet.com/document/fortigate/7.0.11/administration-guide/14295/controlling-return-path-NO.21 Which CLI command do you use to perform real-time troubleshooting for ADVPN negotiation?  get router info routing-table all  diagnose debug application ike  diagnose vpn tunnel list  get ipsec tunnel list NO.22 Refer to the exhibit.Based on the exhibit, which action does FortiGate take?  FortiGate bounces port5 after it detects all SD-WAN members as dead.  FortiGate fails over to the secondary device after it detects all SD-WAN members as dead.  FortiGate brings up port5 after it detects all SD-WAN members as alive.  FortiGate brings down port5 after it detects all SD-WAN members as dead. NO.23 Refer to the exhibit.The exhibit shows the details of a session and the index numbers of some relevant interfaces on a FortiGate appliance that supports hardware offloading. Based on the information shown in the exhibits, which two statements about the session are true? (Choose two.)  The reply direction of the asymmetric traffic flows from port2 to port3.  The auxiliary session can be offloaded to hardware.  The original direction of the symmetric traffic flows from port3 to port2.  The main session cannot be offloaded to hardware. NO.24 Which SD-WAN setting enables FortiGate to delay the recovery of ADVPN shortcuts?  hold-down-time  link-down-failover  auto-discovery-shortcuts  idle-timeout NO.25 Refer to the exhibits.Exhibit A –Exhibit B –Exhibit A shows the traffic shaping policy and exhibit B shows the firewall policy.The administrator wants FortiGate to limit the bandwidth used by YouTube. When testing, the administrator determines that FortiGate does not apply traffic shaping on YouTube traffic.Based on the policies shown in the exhibits, what configuration change must be made so FortiGate performs traffic shaping on YouTube traffic?  Destination internet service must be enabled on the traffic shaping policy.  Application control must be enabled on the firewall policy.  Web filtering must be enabled on the firewall policy.  Individual SD-WAN members must be selected as the outgoing interface on the traffic shaping policy. NO.26 Refer to the exhibits.An administrator is testing application steering in SD-WAN. Before generating test traffic, the administrator collected the information shown in exhibit A.After generating GoToMeeting test traffic, the administrator examined the respective traffic log on FortiAnalyzer, which is shown in exhibit B.The administrator noticed that the traffic matched the implicit SD-WAN rule, but they expected the traffic to match rule ID 1.Which two reasons explain why the traffic matched the implicit SD-WAN rule? (Choose two.)  FortiGate did not refresh the routing information on the session after the application was detected.  Port1 and port2 do not have a valid route to the destination.  Full SSL inspection is not enabled on the matching firewall policy.  The session 3-tuple did not match any of the existing entries in the ISDB application cache. NO.27 Refer to the exhibit, which shows the IPsec phase 1 configuration of a spoke.What must you configure on the IPsec phase 1 configuration for ADVPN to work with SD-WAN?  You must set ike-version to 1.  You must enable net-device.  You must enable auto-discovery-sender.  You must disable idle-timeout. NO.28 Refer to the exhibit.Which conclusion about the packet debug flow output is correct?  The original traffic exceeded the maximum packets per second of the outgoing interface, and the packet was dropped.  The reply traffic exceeded the maximum bandwidth configured in the traffic shaper, and the packet was dropped.  The original traffic exceeded the maximum bandwidth of the outgoing interface, and the packet was dropped.  The original traffic exceeded the maximum bandwidth configured in the traffic shaper, and the packet was dropped. NO.29 Refer to the exhibit.Based on the exhibit, which statement about FortiGate re-evaluating traffic is true?  The type of traffic defined and allowed on firewall policy ID 1 is UDP.  FortiGate has terminated the session after a change on policy ID 1.  Changes have been made on firewall policy ID 1 on FortiGate.  Firewall policy ID 1 has source NAT disabled. NO.30 Refer to the exhibit.Based on the exhibit, which two actions does FortiGate perform on traffic passing through port2? (Choose two.)  FortiGate does not change the routing information on existing sessions that use a valid gateway, after a route change.  FortiGate performs routing lookups for new sessions only, after a route change.  FortiGate always blocks all traffic, after a route change.  FortiGate flushes all routing information from the session table, after a route change. NO.31 Refer to the exhibit.Which configuration change is required if the responder FortiGate uses a dynamic routing protocol to exchange routes over IPsec?  type must be set to static.  mode-cfg must be enabled.  exchange-interface-ip must be enabled.  add-route must be disabled. for using “non ike” routes (for example BGP/static and so on) you must do disable the add-route that inject automatically kernel route based on p2 selectors from the remote site from the SD-WAN_7.2_Study_Guide page 236NO.32 What are two reasons why FortiGate would be unable to complete the zero-touch provisioning process?(Choose two.)  The FortiGate cloud key has not been added to the FortiGate cloud portal.  FortiDeploy has connected with FortiGate and provided the initial configuration to contact FortiManager  The zero-touch provisioning process has completed internally, behind FortiGate.  FortiGate has obtained a configuration from the platform template in FortiGate cloud.  A factory reset performed on FortiGate. NO.33 In the default SD-WAN minimum configuration, which two statements are correct when traffic matches the default implicit SD-WAN rule? (Choose two )  Traffic has matched none of the FortiGate policy routes.  Matched traffic failed RPF and was caught by the rule.  The FIB lookup resolved interface was the SD-WAN interface.  An absolute SD-WAN rule was defined and matched traffic. NO.34 Which three matching traffic criteria are available in SD-WAN rules? (Choose three.)  Type of physical link connection  Internet service database (ISDB) address object  Source and destination IP address  URL categories  Application signatures NO.35 Exhibit.Which conclusion about the packet debug flow output is correct?  The total number of daily sessions for 10.1.10.1 exceeded the maximum number of concurrent sessions configured in the traffic shaper, and the packet was dropped.  The packet size exceeded the outgoing interface MTU.  The number of concurrent sessions for 10.1.10.1 exceeded the maximum number of concurrent sessions configured in the traffic shaper, and the packet was dropped.  The number of concurrent sessions for 10.1.10.1 exceeded the maximum number of concurrent sessions configured in the firewall policy, and the packet was dropped.  Loading … Fortinet NSE7_SDW-7.0 is an exam that tests the knowledge and skills of IT professionals in the field of software-defined wide area networks (SD-WAN). NSE7_SDW-7.0 exam is designed for individuals who are proficient in the design, implementation, and management of complex SD-WAN infrastructures. NSE7_SDW-7.0 exam validates the candidate's ability to configure and troubleshoot SD-WAN technologies, including Fortinet products, and provide effective solutions to meet the needs of customers. Fortinet is a global leader in cybersecurity solutions that protect businesses and organizations from cyber threats. The company offers a wide range of products and services to ensure comprehensive security for networks, endpoints, and cloud environments. Fortinet also provides training and certification programs for security professionals to ensure they have the necessary skills to protect their organizations from cyber attacks.   Get Ready to Pass the NSE7_SDW-7.0 exam with Fortinet Latest Practice Exam : https://www.braindumpsit.com/NSE7_SDW-7.0_real-exam.html --------------------------------------------------- Images: https://blog.braindumpsit.com/wp-content/plugins/watu/loading.gif https://blog.braindumpsit.com/wp-content/plugins/watu/loading.gif --------------------------------------------------- --------------------------------------------------- Post date: 2023-10-31 14:52:21 Post date GMT: 2023-10-31 14:52:21 Post modified date: 2023-10-31 14:52:21 Post modified date GMT: 2023-10-31 14:52:21