QUESTION 22
What is an acceptable SSD configuration for an XtremIO X1 cluster?

QUESTION 23
On an XtremlO X2-S, which ports are used on the InfiniBand switches for an ISL connection?

QUESTION 24
When preparing for a single-to-dual online cluster expansion, which power cables are pre-staged by being connected to PDU-B only?

QUESTION 25
Where can the XtremlO power requirements be found?

QUESTION 26
How much rack space is required for a four X-Brick XtremIO X2 cluster with a physical XMS?

QUESTION 27
How many connectors, and of which type(s), are used on the Eaton 1550 Evolution BBU?

QUESTION 28
What is the correct sequence of steps to perform a planned shutdown of an XtremIO X2?

QUESTION 29
What is the correct sequence of steps to install a virtual XMS prior to creating the cluster on an XtremIO X2?

QUESTION 30
After changing the IP addresses of the Storage Controllers, which XMCLI command is used to verify that those addresses are correct?

QUESTION 31
If an XtremlO X2 array experiences a power failure, which components will protect the journal data?

QUESTION 32
Refer to the Exhibit.

Based on the exhibit, which rows of drives are used for DPG-2 in an XtremIO-X2 DAE?

QUESTION 33
In an XtremIO X2, what is the maximum number of lifetime cycles for NVRAM?

QUESTION 34
Which document should be referenced when modifying the IP addresses on an XtremIO X2 cluster that will remain in the same IP network?

QUESTION 35
What is the maximum mixed read/write IOPS rate achievable in a two X-Brick XtremIO X2 array?

QUESTION 36
What is the minimum number of SSDs required to upgrade a single X-Brick XtremIO X2 cluster that contains 36 SSDs?

QUESTION 37
In addition to the cluster name, which parameters are required for creation of the cluster?

QUESTION 38
How many drives can be lost from a full data protection group before a data loss occurs on an XtremIO X1?