NO.11 An engineer wants to change an existing transparent Cisco FTD to routed mode.
The device controls traffic between two network segments. Which action is mandatory to allow hosts to reestablish communication between these two segments after the change?

NO.12 Which CLI command is used to control special handling of clientHello messages?

NO.13 When deploying a Cisco ASA Firepower module, an organization wants to evaluate the contents of the traffic without affecting the network. It is currently configured to have more than one instance of the same device on the physical appliance Which deployment mode meets the needs of the organization?

NO.14 What is a functionality of port objects in Cisco FMC?

NO.15 Which two OSPF routing features are configured in Cisco FMC and propagated to Cisco FTD? (Choose two.)

NO.16 Which two considerations must be made when deleting and re-adding devices while managing them via Cisco FMC (Choose two).

NO.17 A network administrator reviews the file report for the last month and notices that all file types, except exe. show a disposition of unknown. What is the cause of this issue?

NO.18 An engineer must build redundancy into the network and traffic must continuously flow if a redundant switch in front of the firewall goes down. What must be configured to accomplish this task?

NO.19 A network administrator is implementing an active/passive high availability Cisco FTD pair.
When adding the high availability pair, the administrator cannot select the secondary peer.
What is the cause?

NO.20 When an engineer captures traffic on a Cisco FTD to troubleshoot a connectivity problem, they receive a large amount of output data in the GUI tool. The engineer found that viewing the Captures this way is time-consuming and difficult lo son and filter. Which file type must the engineer export the data in so that it can be reviewed using a tool built for this type of analysis?

NO.21 Which two actions can be used in an access control policy rule? (Choose two.)

NO.22 An engineer is setting up a new Firepower deployment and is looking at the default FMC policies to start the implementation During the initial trial phase, the organization wants to test some common Snort rules while still allowing the majority of network traffic to pass Which default policy should be used?

NO.23 What is a result of enabling Cisco FTD clustering?

NO.24 An engineer must deploy a Cisco FTD device. Management wants to examine traffic without requiring network changes that will disrupt end users. Corporate security policy requires the separation of management traffic from data traffic and the use of SSH over Telnet for remote administration. How must the device be deployed to meet these requirements?

NO.25 Which CLI command is used to control special handling of ClientHello messages?

NO.26 An engineer plans to reconfigure an existing Cisco FTD from transparent mode to routed mode. Which additional action must be taken to maintain communication Between me two network segments?

NO.27 An organization is using a Cisco FTD and Cisco ISE to perform identity-based access controls. A network administrator is analyzing the Cisco FTD events and notices that unknown user traffic is being allowed through the firewall. How should this be addressed to block the traffic while allowing legitimate user traffic?

NO.28 Which two OSPF routing features are configured in Cisco FMC and propagated to Cisco FTD? (Choose two.)

NO.29 Refer to the exhibit.

An administrator is looking at some of the reporting capabilities for Cisco Firepower and noticed this section of the Network Risk report showing a lot of SSL activity that cloud be used for evasion. Which action will mitigate this risk?

NO.30 Which CLI command is used to control special handling of ClientHello messages?

NO.31 Which interface type allows packets to be dropped?

NO.32 An administrator is creating interface objects to better segment their network but is having trouble adding interfaces to the objects. What is the reason for this failure?