NO.76 You are deploying IP phones in your enterprise networks. When plugged in, the IP phones must automatically negotiate the power requirements for the new connection with the EX Series switches.
In this scenario, which protocol should be used to enable this behavior?

NO.77 Referring to the exhibit, which two statements are correct? (Choose two.)

NO.78 A Layer 2 connection does not expend across data centers. The IP subnet in a Layer 2 domain is confined within a single data center.
Which EVPN route type is used to communicate prefixes between the data centers?

NO.79 Which two multicast listener registration protocols are supported in the Junos operating system?
(Choose two.)

NO.80 You are deploying IP phones in your enterprise network that must receive their power through their Ethernet connection. You are using your EX Series switch’s PoE ports that support IEEE
802.3af. In this scenario, what is the maximum amount of power allocated to each interface?

NO.81 Your organization has recently acquired another company. You must carry all of the company’s existing VLANs across the corporate backbone to the existing branch locations without changing addressing and with minimal configuration.
Which technology will accomplish this task?

NO.82 Which two multicast listener registration protocols are supported in the Junos operating system? (Choose two.)

NO.83 You are implementing a single spanning tree instance in your network and want to use the protocol that will give you the best convergence time in the event of a physical network failure of the root bridge. Which spanning tree protocol will satisfy this requirement?

NO.84 Referring to the exhibit, which two statements are correct? (Choose two.)

NO.85 Your enterprise network uses routing instances to support multitenancy. Your Junos devices use BGP to peer to multiple BGP devices. You must ensure that load balancing is achieved within the routing instance.
Which two statements would accomplish this task? (Choose two.)

NO.86 You have a workstation and an IP phone that connect to the same physical port on your Juniper switch. Which statement is true?

NO.87 BGP multipath or multihop are not configured in your network. In this scenario, what is the correct sequence for BGP active route selection?

NO.88 When configuring class of services, what would be you use to allocate bandwidth to a forwarding class?

NO.89 Which statement is correct about IS-IS?

NO.90 You are asked to merge a RIP network with your OSPF network. As a first step, you establish connectivity between the RIP network and the OSPF network. The RIP network connects to an NSSA area. Which two statements are true in this scenario? (Choose two.)

NO.91 You want to create an OSPF area that only contains intra-area route information in the form of Type 1 and Type 2 LSAs.
In this scenario, which area is needed to accomplish this task?

NO.92 You are asked to configure 802.1X on your access ports to allow only a single device to authenticate.
In this scenario, which configuration would you use?

NO.93 You are running OSPF as your IGP. The interfaces connecting two routers are in the ExStart state. You notice that something is incorrect with the configuration. Referring to the exhibit, which statement is correct?

NO.94 Referring to the exhibit, which statement is correct?

NO.95 What are two supported PoE management modes? (Choose two.)

NO.96 Which two statements are correct regarding the behavior shown in the exhibit? (Choose two.)

NO.97 You are deploying IP phones in your enterprise network that must receive their power through their Ethernet connection. You are using your EX Series switch’s PoE ports that support IEEE 802.3af.
In this scenario, what is the maximum amount of power allocated to each interface?