Q108. A consultant needs to upgrade the ESXi hosts on a Nutanix cluster from version 6.7 to 7.0. vSphere DRS and wMoton are working properly. The consultant needs to use One-Click Upgrade.
Which setting should be verified by the consultant?

Q109. An organization subscribes to field advisories from the Nutanix support portal. An administrator receives an email about a rare problem that could cause cluster instability and affect the entire AOS cluster. The organization is running Vmware vsphere 6.x on Nutanix.
What action should be taken to resolve this issue?

Q110. A consultant wants to expand a Nutanix cluster based on Dell PowerEdge servers and notices the nodes have arrived software-less.
Which two actions should the consultant take to expand the cluster? (Choose two.)

Q111. During a six-node cluster deployment, one node fails to image successfully and Foundation is unable to automatically configure the cluster. The consultant decides to manually complete cluster formation with the successful nodes, then expand the cluster with the remaining unconfigured node.
Which command should be used to begin the process?

Q112. A consultant is onsite with a customer running Foundation VM (FVM) and discovers that there is no connectivity between the FVM and their laptop. The consultant verifies the following:
* The consultant’s laptop and Nutanix nodes are plugged into a flat switch.
* The laptop, switch and nodes are plugged into supported power supplies.
* The laptop network adapters and FVM are configured with their corresponding IP addresses.
What is the cause for the connectivity failure to the FVM?

Q113. A customer wants to run SAP HANA on a Nutanix cluster with the following characteristics:
* AHV nodes
* SAP HANA version 2
* Production database files
Which configuration should be recommended to the customer?

Q114. A consultant is performing a Nutanix Cluster installation on Dell XC Core hardware. The consultant decides to use Foundation Portable for Mac to perform the installation. When the consultant arrives onsite, Foundation Portable is unable to locate the new nodes.
Which log should the consultant check to troubleshoot this issue?

Q115. An administrator has a 32-node hybrid cluster with CPU, RAM and storage utilization of 80%. A database VM is configured with VM Flash.
What is causing this IO latency?

Q116. An administrator is implementing a VDI solution. The workload will be a series of persistent desktops in a dedicated storage container withina four-node cluster. Storage optimizations should be set on the dedicated storage container to give optimal performance including during a node failure event.
Which storage optimizations should the administrator set to meet the requirements?

Q117. A consultant is preparing to add new nodes into an existing cluster. The current cluster AOS version is 5.8.
The new expansion node is currently running AOS 5.9 code. The cluster must continue to run at its current AOS version.
Which method can be used to successfully add the node?

Q118. A consultant has deployed a Nutanix cluster with AOS 5.10.x, then discovers the customer’s environment is running on AOS 5.6.x. The consultant decides to re-image the cluster using the foundation Java applet. During the Foundation discovery, all cluster nodes display a status of Unavailable.
What should the consultant do to resolve the issue?

Q119. Refer to the exhibit.

An administrator has an existing cluster and needs to improve performance using AHV Turbo. Which two items are required to achieve even greater performance? (Choose two.)

Q120. An administrator is concerned that Prism will be inaccessible if Active Directory is unable to process logins.
Which method should the administrator use to access the cluster in the event of this type of outage?

Q121. A consultant is using a customer’s switch for installation. Although the 10GbE ports for each of the hosts are connected to the switch, the nodes fail to be discovered.
What is causing the issue?

Q122. A consultant is completing final network failover testing on a recently deployed AHV cluster.
The cluster consists of the following:
*Three nodes
*Two uplinks connected to two switches
*Supported SFPs
The consultant removed one SFP+ out of each node. Two of the nodes (Hostl I Host2) failed over to the backup NIC correctly without any interruption but have lost communication with the third node (Host 3) hypervisor/CVM. Inserting the original SFP+ back into the problematic node allowed the network to be connected and the two healthy nodes could communicate successfully again.
manage_ovs showjnterfaces output
manage_ovs showjinterfaces output:
name mode link speed
cthO 10000 True 10000
ethl 10000 False None
eth2 10000 True 10000
eth3 10000 False None
manage_ovs show.uplinks output:
Bridge: brO
Bond: brO-up
bond_mode: active-backup
interfaces: ethl ethO
lacp: off
lacp-fa I 1 back: false
lacp_speed: slow
What should the consultant validate first?

Q123. A consultant asks a customer to verify the ToR Switch data port configuration was done according to Nutanix best practices. The switch configuration must simplify future deployments and expansions.
Which two configuration actions will satisfy this requirement? (Choose two.)

Q124. A consultant is deploying a two-node cluster at a remote branch office.
Which component must be available to complete cluster configuration?

Q125. A consultant configures a Nutanix cluster and integrates the hosts into vCenter using VMware best practices.
The customer has requested that the Nutanix cluster only have a single datastore.
Upon configuring the cluster per the customer requirements, vCenter displays an alert regarding the heartbeat datastore. The consultant adds the das.ignoreInsufficientHbDatastore value = true rule. The container can be seen from each host, but the alert remains active.
What should the consultant do to resolve this issue?

Q126. During the knowledge transfer on Prism GUI, a customer asked about AHV best practices for VM High Availability on a five-node cluster and the safest configuration. The consultant informed the customer that best practices dictate that all storage containers are configured with a replication factor of 3.
What will be the behavior if the non-default Guarantee mode is selected on Prism with two AHV host failures?

Q127. A consultant is using the Foundation applet to create a cluster. During the process the consultant refreshes the progress bar web page and is concerned when nothing loads.
What should the consultant do to verify that Foundation has completed successfully?

Q128. An administrator is deploying an application using Nutanix Volumes. After configuring the volume group and connecting the guest’s iSCSI initiator to the volume group, they begin performance testing.
The administrator learns that performance on the virtual disk attached to the iSCSI initiator is far less than that of a virtual disk connected directly to the VM.
Which situation is causing this condition?

Q129. For a new AHV cluster installation, a customer has 20 NX-8155 nodes with quad port NICs. The customer wants to meet the following guidelines:
Take advantage of all available 10G links
Achieve maximum throughput per VM
Use of redundant ToR switches
Fastest reconvergence during link failure
How should the load balancing be configured on the host?

Q130. A customer wants to validate the Microsoft SQL workload performance for a CRM application before migration to the new Nutanix cluster.
Which activity must the consultant add as part of the test plan to fulfill this requirement?

Q131. An administrator receives a notification that storage in a Nutanix cluster is unavailable. The cluster consists of five nodes and is configured with a Fault-Tolerance level of 1 (FT-1).
Upon investigation, the administrator finds the following:
* All AHV hosts are powered on and the CVMs are running
* Nodes A, B, and C are connected to one top of rack switch
* Nodes D and E are connected to a second top of rack switch
* The cluster status command run on Node A shows that CVM services on nodes D and E are down Which issue is causing the storage outage?