300-425 Questions Prepare with Learning Information! 2025 Regularly updated [Q11-Q27]

Rate this post

300-425 Questions Prepare with Learning Information! 2025 Regularly updated

Get 300-425 Products Practice Material for 300-425 Exam Question Preparation

NEW QUESTION 11
An engineer is designing a new wireless network. The network needs to ful_ll the following requirements:
* support multimedia applications
* support a high concentration of wireless clients
* support data over wireless
* support roaming
Which approach should be used?

use of micro cells with reduced power levels

use of macro cells with reduced power levels

coverage for cells at maximum power levels

use of macro cells with maximum power levels

NEW QUESTION 12
Why is 802.11a connectivity reduced in an X-ray room?

X-rays create significant non-Wi-Fi interference on the 802.11a band.

X-rays impact the 802,11a UNll-2 channels that cause access points to dynamically change channels.

X -rays within these rooms cause multipath issues.

X-ray rooms exhibit increased signal attenuation.

NEW QUESTION 13
An engineer is using a Cisco AIR-2702i AP lo conduct a Layer l site survey.
Which mode is selected for the AP to discover non Wi-Fi interference with Metageek Chanaryzer?

Sniffer

FlexConnect

Monitor

SE-Connect

NEW QUESTION 14
Which Cisco IOS VPN technology leverages Ipsec, mGRE, dynamic routing protocol, NHRP, and Cisco Express Forwarding?

FlexVPN

DMVPN

GETVPN

Cisco Easy VPN

NEW QUESTION 15
Which statement about creating a mobility group is true, excluding mobility anchors?

Each WLC must use the same mobility name and be defined as a peer in each other’s static mobility members list.

If WLCs with HA SSO are deployed, each WLC in the WLC HA pair considered separately as a mobility peer.

The WLCs do not have to be of the same model or type to be a member of a mobility group, however each member should be running different software versions.

A mobility groups does not require all WLCs in the group to use the same virtual IP address.

NEW QUESTION 16
A wireless consultant reviewing the installation of an old wireless network. The existing AireOS controllers are running software version 6.0.4539:44024. The customer is using OEAP and wants to keep this functionality. Which licenses should the consultant propose with the latest controller software version?

Base

Premium

WPlus

Advanced

NEW QUESTION 17
An engineer as performing a Layer 1 passive wireless site survey utilizing a channel analyzer software in the 2.4 GHz spectrum. Which chart indicates the ratio of interference present during the duration of the capture?

NEW QUESTION 18
A customer has noticed that Client Band Select is enabled and no clients are utilizing the 5 GHz band. Which three parameters must be met to ensure that wireless clients use the 5 GHz band? (Choose three.)

Ensure that channel bonding is enabled on the WLAN.

Ensure that the co-channel interference has not exceeded -85 dBm.

Ensure tha the UNII-2 extended channels are enabled on the 802.11a radios.

Ensure that the client is receiving RSSI above the minimum band select RSSI threshold.

Ensure that the client is dual-band capable.

Ensure that the WLAN has 802.11a enabled.

NEW QUESTION 19
A company has 10 access point licenses available on their backup Cisco WLC and their primary Cisco WLC is at full capacity, 5 access points are set to high failover priority and 7 access points are set to critical failover priority.
During a failure, not all critical access points failed over to the backup Cisco WLC.
Which configuration is the cause of this issue?

The high priority access point is oversubscribed.

network ap-priority is set to enable.

The critical priority access point count is oversubscribed.

network ap-priority is set to disable.

NEW QUESTION 20
A university is in the process of designing a wireless network in an auditorium that seats 500 students and supports student laptops. Which design methodology should the university implement in the auditorium?

roaming design model

voice design model

location design model

high-density design model

NEW QUESTION 21
Refer to the exhibit.

What is the main reason why the Wi-Fi design engineer took a different approach than installing the APs in the offices, even though that installation provides better coverage?

aesthetics

transmit power considerations

antenna gain

power supply considerations

NEW QUESTION 22
A wireless engineer is performing a post verification of a wireless network. Which two metrics does the engineer verify to ensure that the wireless network can support voice services? (Choose two.)

The coverage area must have a noise floor that does not exceed -87 dBm.

The client device must have at least an -67 dBm RSSI.

The rate of retransmitted packets must be 15 percent or below.

The rate of retransmitted packets must be 20 percent or below.

The client device must have at least an -65 dBm RSSI.

NEW QUESTION 23
An engineer must install an outdoor wireless network for an area with a direct line of sight. The outdoor APs are in an open area with of harsh weather. Which two parameters must the engineer consider to prevent an outdoor wireless outage? (Choose two.)

lightning arrestor installation

antenna cable grounding

cable strength

cable length

elimination of trees

NEW QUESTION 24
An engineer must deploy a wireless network in an open-plan environment that has three SSIDs using the 5 GHz band set to 40 MHz. Co-channel interference must be reduced. Which two actions must be taken? (Choose two.)

Increase the number of SSIDs.

Increase channel bonding in the 2.4 GHz band to 40 MHz.

Disable band steering.

Decrease channel bonding in the 5 GHz band to 20 MHz.

Reduce the power of the AP.

NEW QUESTION 25
Which statement about creating a mobility group is true, excluding mobility anchors?

Each WLC must use the same mobility name and be defined as a peer in each other’s static mobility members list.

If WLCs with HA SSO are deployed, each WLC in the WLC HA pair considered separately as a mobility peer.

The WLCs do not have to be of the same model or type to be a member of a mobility group, however each member should be running different software versions.

A mobility groups does not require all WLCs in the group to use the same virtual IP address.

NEW QUESTION 26
An engineer is performing an AP-on-a-stick survey and finds that the 5 GHz channel overlap is too high when an appropriate number of APs are used for the density requirements. Which two actions during the survey reduce channel overlap? (Choose two.)

Raise the minimum data rate to 24 Mbps.

Increase AP transmit power to improve the SNR.

Allow the use of UNII-2e channels.

Use directional antennas to limit the coverage area of some APs.

Enable power saving mode.

NEW QUESTION 27
Based on a wireless network design, an engineer configured a primary and secondary controller for their APs. A power interruption caused the primary Cisco WLC to go down, and, as expected, all APs joined the secondary controller. When the primary controller came back up, all the APs remained joined to the secondary controller. Which approach must the engineer take for the APs to move back to the primary?

Set AP Fail over Priority to 4 on each AP.

Set AP Fallback to Enabled on the secondary controller.

Set AP Fallback to Enabled on the primary controller.

Set AP Fail over Priority to Critical globally.

Earning the Cisco 300-425 certification is a valuable achievement for IT professionals who want to advance their careers in wireless networking. Designing Cisco Enterprise Wireless Networks certification is recognized globally as a mark of expertise in designing and deploying enterprise wireless networks. With this certification, candidates can demonstrate their ability to design and implement wireless networks that meet the needs of modern businesses, including high performance, reliability, and security.

Most Reliable Cisco 300-425 Training Materials: https://www.braindumpsit.com/300-425_real-exam.html