NO.36 Click the Exhibit button.

You are setting up a new AFF A700 into a new rack at a customer’s site. The customer asks you to plan for simplified future growth.
Referring to the exhibit, how would you satisfy this requirement?

NO.37 You are planning to update your running switch environment. You must know that certain conditions exist before the FASTPATH software and the RCF on a NetApp CN1610 cluster switch can be installed.
Which condition must exist in this scenario?

NO.38 Which NetApp tool should you use to set up an ONTAP 9.5 cluster?

NO.39 An ONTAP cluster is installed at a secure site. The array has no access to the Internet but is managed 24/7 by onsite engineers. The customer requires that when hardware failures occur, the failures are reported to the NetApp Support team as quickly as possible.
In this scenario, which two tasks should be performed during the project hand-off procedure to satisfy the customer’s requirement? (Choose two.)

NO.40 You finished a new installation and executed Config Advisor successfully. You review the physical racking and cabling on one of the controllers, and notice an amber light that was not previously on.
Which two actions should you perform before you turn over the cluster for production? (Choose two.)

NO.41 You complete a hardware installation on a CN1610 switch and establish a serial connection to the RJ45 port.
In this scenario, the established serial connection allows the installer to complete which two tasks for the switches initial configuration? (Choose two.)

NO.42 You are installing a new AFF A400 cluster for a customer. The customer indicates that they want to take advantage of AutoSupport On Demand.
In this scenario, which AutoSupport transport protocol must you use?

NO.43 You want to ensure the highest path resilience and performance increase to the storage stack on your FAS8700 cluster.
In this scenario, which two types of stack cabling are available to use? (Choose two.)

NO.44 You install a new 2-node FAS8200 switchless cluster. You want to reach all necessary management LIFs and SPs for this cluster.
How many management IP addresses do you need in this scenario?

NO.45 You want to create a new intercluster LIF for cross-cluster replication and use the CLI. After you create the nac101_intercluster_lif_icl LIF, you are not able to see the LIF in the list of local intercluster LIFs.

Referring to the exhibit, what is the problem?

NO.46 You are asked to add a new HA pair to an existing 2-node switchless AFF A220 cluster. You must first convert to a 2-node switched cluster using Broadcom BES-53248 cluster switches.
Which two conditions must be fulfilled before you start the migration? (Choose two.)

NO.47 Which two SVMs are automatically created during the cluster setup? (Choose two.)

NO.48 You have set up a new 2-node switchless cluster and want to verify that the failover is configured correctly.
In this scenario, which two commands accomplish this task? (Choose two.)

NO.49 Click the Exhibit button.

Referring to the exhibit, what information is forwarded to syslog after you enter the scripted install commands? (Choose two.)

NO.50 Which two SVMs are automatically created during the cluster setup? (Choose two.)

NO.51 While installing a new AFF A400 HA pair, you are unable to add an NTP server from another subnet. You are able to ping the NTP server from the new cluster.
In this scenario, what are two causes of this problem? (Choose two.)

NO.52 Click the Exhibit button.

You are installing a new FAS cluster. The management network must be on tagged VLAN 11 for remote administration by a service provider.
Referring to the exhibit, which two ports will allow service provider access to both cluster and node management LIFs? (Choose two.)

NO.53 You are cabling two Cisco 3232C switches for the cluster interconnect of a 4-node AFF A800 cluster.
Which pair of ports are used to cable the Inter-Switch Link (ISL) between the switches?