Q29. Click the Exhibit button.

Referring to the exhibit, the GRE tunnel between R-1 and R-2 allows connectivity between User-1 and Server-1. When User-1 communicates with Server-2 with packets that are 1472 bytes in size, no packet fragmentation occurs. User-1 can communicate with Server-1 with packets that are up to 1448 bytes in size with no packet fragmentation. However, if the packet size is larger than 1448 bytes, packet fragmentation occurs.
Why is the packet fragmentation occurring between User-1 and Server-1 in this scenario?

Q30. Click the Exhibit button.

You must create a static route on Router-A to the 10.10.5.0/24 network using 10.10.3.2 as the next hop.
Referring to the exhibit, which configuration accomplishes this task?

Q31. What are tree types of interfaces that can be used in an MX Series device when implementing a virtual switch routing instance? (Choose three.)

Q32. What happens when a packet matches a static route with the next hop parameter set to reject?

Q33. Which two statements are true when configuring OSPF authentication? (Choose two.)

Q34. You want to disable MAC learning only for interface ge-0/0/0.0 on an MX Series device.
Which syntax will accomplish this task?

Q35. By default, the Junos OS advertises which address(es) in LDP forwarding equivalency class (FEC) messages?

Q36. Click the Exhibit button.

Referring to the exhibit, which two statements are true? (Choose two.)

Q37. Click the Exhibit.

Referring to the configuration in the exhibit, which statement is true?

Q38. Which Layer 2 mechanism logically groups network nodes into separate broadcast domains?

Q39. You have a stub OSPF area running in your network. Your supervisor has asked you to build a virtual link across this area to connect new equipment acquired in a recent ISP acquisition.Which statement is correct about this scenario?

Q40. Click the Exhibit button.

Which type of route is shown in the exhibit?

Q41. You are asked to change the default TTL handling behavior on your Junos device to ensure that the RSVP- signaled LSPs in your MPLS network cannot be mapped.
Which configuration should be performed to accomplish this task?

Q42. You have been asked to use a convention that allows for auto configuration of interface addresses.
You are not allowed to use DHCPv6. What do you do?

Q43. Click the Exhibit.

Referring to the exhibit, which IS-IS router will be selected as the DIS?

Q44. Click the Exhibit button.

Referring to the exhibit what are two reasons for the configuration stanza? (Choose two.)

Q45. What are three ways to configure IPv6 addresses in your network? (Choose three.)

Q46. Click the Exhibit button. Which two topologies shown in the exhibit could be implemented without a spanning-tree protocol? (Choose two.)

Q47. Which two configuration elements must match on all switches participating in the same MSTP region? (Choose two.)

Q48. Click the Exhibit button.

You have applied the policy shown in the exhibit to the forwarding table on an MX Series device. How is traffic load-balanced?

Q49. Which statement correctly describes a characteristic of IPv6 unicast addressing?