QUESTION 101
Referring to the exhibit, on which three IS-IS routers will the attached bit be set? (Choose three.)

QUESTION 102
When redistributing IGP routes into BGP. what information .s used by default on Junos platforms to determine the BGP route’s MED attribute value?

QUESTION 103
You are asked to merge a RIP network with your OSPF network. As a first step, you establish connectivity between the RIP network and the OSPF network. The RIP network connects to an NSSA area. Which two statements are true in this scenario? (Choose two.)

QUESTION 104
You are implementing 802.1x authentication in your Layer 2 network. Each user will have a computer and a phone and you must ensure that both device are authenticated individually. In this scenario, which supplicant mode should be used?

QUESTION 105
Which EVPN route type is used for fast convergence and for advertising the split horizon label?

QUESTION 106
Click the Exhibit.

You have a workstation and VoIP phone connected to port ge-0/0/1 on an access switch.
Referring to the configuration shown in the exhibit, which statement is true?

QUESTION 107
Your network has Junos Fusion configured with MX960 routers as aggregation devices (AD) and QFX5100 switches as satellite devices (SO) Which two statements are coned in this scenario?
(Choose two )

QUESTION 108
Referring to the exhibit, anycast RP is implemented to ensure multicast service availability. The source is currently sending multicast traffic using group 239.1.1.1 and R3 is receiving PIM register messages, but R2 does not have active source information. In this scenario, what are two methods to receive the active source information on R2? (Choose two.)

QUESTION 109
What are two similarities between OSPFv2 and OSPFv3? (Choose two.)

QUESTION 110
Your IS-IS adjacency is not established as shown in the exhibit. What is the problem?

QUESTION 111
A customer on MSTI-2 was isolated due to a physical link outage on Switch 5’s ge-0/0/32 interface.

Referring to the exhibit, which corrective action would solve this problem?

QUESTION 112
You have PIM SM multicast configure and running in a network environment comprised of EX4300 devices. Your customer report increased delay when switching channels using IPTV. To help decrease the delay, you implement PIM join balancing. You add the set protocol pim join- load-balance command to the configuration. After committing, you notice that the flows are still using one path.
In this scenario, which statement is correct?

QUESTION 113
Which three statements are correct about EVPN route types? (Choose three.)

QUESTION 114
You are configuring an EVPN overlay to allow VLANs to be stretched between two campus sites, but EVPN routes are not being exchanged. Referring to the exhibit, which configuration statement would solve this problem?

QUESTION 115
Click the Exhibit button.

You receive the same 75.100.0.0/16 route from all four ISPs to which you are connected.
Referring to the exhibit, which ISP’s route will be selected as active?

QUESTION 116
A user is attempting to watch a high-definition video being streamed from the media server over the network. However, the user complains that the experienced video quality is poor. While logged on to router B, a Juniper Networks device, you notice that video packets are being dropped.
In this scenario, what would solve this problem?

QUESTION 117
Which protocol allows a switch to pass configuration information to an IP phone?