[Jul-2024] Use Real HPE7-A07 Dumps Free Sample Questions and Practice Test Engine [Q42-Q63]

5/5 - (1 vote)

[Jul-2024] Use Real HPE7-A07 Dumps Free Sample Questions and Practice Test Engine

Pass HP HPE7-A07 exam – questions – convert Tets Engine to PDF

NEW QUESTION 42
You are testing the use of the automated port-access role configuration process using RadSec authentication over VXLAN. During your testing you observed that the RadSec connection will fan during the digital certificate exchange What would be the cause of this Issue?

The RadSec server was defined on the switch using an IPv6 address that was unreachable

Tracking mode was set to “dead-only”, and the RadSec server was marked as unreachable.

The switch is configured to establish a TLS connection with a proxy server, not the radius server.

The RADIUS TCP packets are Being dropped and the TLS tunnel is not established.

NEW QUESTION 43
You are deploying a new AOS 10 mobility gateway cluster. Due to customer requirements, the gateways must be configured with static IP addresses and are restricted from communicating using port 443 to any URLs except tor “central arubanetworks.com How would you onboard these gateways successfully into HPE Aruba Networking Central?

NEW QUESTION 44
An administrator is creating a fabric withNetConductor in HPE Aruba Networking Central Considering an EVPN VXLAN fabric, click on the most appropriate layer to be configured as a Rome-Reflector Persona.

NEW QUESTION 45
Exhibit.

Which statement is true given the following CLI output from a CX 6300?

There are no active fabric clients on the CX switch with RD 172.16.10.1

A wired client with IP address 10.203 1.100 is on a remote CX 6300 in the fabric with loopback IP address 172.21.11.2.

A wired client with IP address 10 203 1 100 has a host route that is not being properly advertised

The overlay loopbacK addresses are advertised in the faerie with 2d-bit subnet masks

NEW QUESTION 46
Refer to the CLI output below:

What statement about the output above is correct?

The port-access role was configured with gateway-role visitor

The secondary tunnel endpoint IP is 10.10-10.151.

The client authenticated using dot1x.

The UBT zone was configured to use a user-defined VRF

NEW QUESTION 47
An ACME company employee complained about a recent poor-quality VoIP call while moving aroundtheir office environment HPE Aruba Networking Central reported a fair UCC score for this callwhile your VoIP engineer reported that their systems reported a MOS of 2,3. The VoIP devices are operatingover the 5GHz frequency band.
What are the possible contributing factors? (Select two.)

Coverage AP deployment plans generally don’t support enough cell overlap for VoIP.

802.tr is enabled in the WLAN Security settings.

There was localized interference at the caller’s location

802.1K is disabled in the WLAN Security settings

The client roamed into an area that continuously operates Zigbee.

NEW QUESTION 48
Exhibit.

A customer is reporting mat connectivity is Tailing for some wireless client Devices. What are your conclusions from the capture? (Select two.)

The client does not have an ARP entry for me default gateway.

The network is using WPA2-PSK key management.

The network is using WPA3-SAE key management.

The client is not receiving an IP address.

The client does not support beamforming.

NEW QUESTION 49
Refer to the exhibit.

Which statement is true?

The client performed passive scanning

The client is using BSS Fast Transition

The client is failing 802.1X authentication

The client used an incorrect passphrase

NEW QUESTION 50
Which statements accurately describe OSPF Graceful Restart (when the restarting router is able to Keep its forwarding tables across the restart)? (Select two.)

The GR helper role is supported on AOX-CX 6100 switches.

VSF Failover and Graceful-Restart require a VSF secondary member in the VSF stack

Bidirectional Forwarding Detection for OSPF and GR are mutually exclusive features.

OSPF Routers listen for Grace-LSAs on each network segment where there is an OSFP adjacency.

You must ensure your VSF stack has a secondary member when acting as a GR helper

NEW QUESTION 51
A customer’s infrastructure is set up to use both primary and secondary gateway clusters on the SSID profile based on best practices What is a valid cause tor having an equal spirt in APs connected to the primary and secondary gateway clusters?

The secondary gateway cluster is heterogeneous

The secondary gateway cluster is homogeneous

The primary gateway cluster is up. out some APs are unable to reach the primary gateway cluster. These APs would connect to the secondary gateway cluster

The primary gateway cluster is up. out some APs cannot reach the secondary gateway cluster. These APs would connect to the secondary gateway cluster

NEW QUESTION 52
Your customer is requesting a4-ciass LAN queuing model tor QoS. Following best practices, match the PHB/DSCP values to the application types.

NEW QUESTION 53
A customer has deployed an AOS 10 mobility gateway cluster consisting of three controllers at a single site The WLAN is configured to tunnel wireless device traffic to the AOS 10 mobility cluster The clients are authenticated by ClearPass using WPA3-Enterprise (opmode wpa3-aes-ccm-128). The security team has requested the ability to force a wireless device to reauthenticate using ClearPass.
Which steps are required to ensure ClearPass can consistently initiate a change of authorization against an AOS 10 mobility cluster, including during gateway failover scenarios? (Select two)

set cluster mode to Auto Site under High Availability – Cluster configuration

modify WLAN – SSID – VLAN – Mode Configuration

enable manual cluster configuration under High Availability – Cluster Configuration

enable Dynamic Authorization CoA under High Availability – Cluster Configuration

modify NAS IPv4 address under Security – Advanced – RADIUS Client

NEW QUESTION 54
You are troubleshooting a WLAN deployment with APs and gateways set up with an 802.1X tunneled SSIO.
End-users are complaining that they can’t connect to die enterprise SSID. Which possible AP tunnel states could be the cause of the Issue? (Select two.)

SM_STATE_RE KEYING

SM_STATE_SURVIVED

SM_STATE_CONNECTED

SM_STATE_SURVIVING

SM_STATE_CONNECTING

NEW QUESTION 55
A customer is planning to add loT devices that connect wirelessly to the existing 802.1X SSlD. The customer will use ClearPass to authenticate the IoT devices by MAC address but other devices will still need to authenticate by only 802 1X Exhibit.

The customer provided the current configuration and reported their non-loT 802. IX devices are no longer able to connect. Which configuration change can be made to fix the issue?

Modify opmode wpa3-aes-gcm-256 to opmode wpa2-aes

Add i2-autn-fairtnrougn to the WLAN configuration

Remove mac-authentication from the WLAN configuration

Modify max-authentication failures to 0.

NEW QUESTION 56
A network administrator wants to configure an 802 1X supplicant for a wireless network that includes the following:
1. AES encryption
2. EAP-MSCHAPv2-based user and machine authentication
3. validation of server certificate in Microsoft Windows 10
The network administrator creates a WLAN profile and selects the change connection settings option Then the network administrator changes the security type to Microsoft Protected EAP (PEAP) and enables user and machine authentication under Additional Settings.
What must the network administrator do next to accomplish the task?

Enable user authentication

Change the security type to Microsoft: Smart Card or other certificate.

Change default RC4 encryption for AES

Enable server certificate validation

NEW QUESTION 57
Exhibit.

Which statement is true?

The SSID supports HR-DSSS data rates

The SSID is supports 6 GHz clients.

The SSID supports 802 11ax clients.

The SSID supports 802 11ac clients.

NEW QUESTION 58
Exhibit.

Which would explain this issue?

HTTPS wildcard certificates are not supported

HTTPS certificate is not required in ClearPass Guest.

captiveportal-login aruba-training com needs to be entered m the Address field for the ClearPass Guest

“.aruba-training com needs to be entered in the Address field for the ClearPass Guest

NEW QUESTION 59
What directly affects the MCS used by wireless stations? (Select two.)

SNR

retry rate

channel utilization

number of connected clients

frequency band

NEW QUESTION 60
You configured” a bridgedmode SSID with WPA3-Enterprise and EAP-TLS security. When you connect an Active Directory joined client that has valid client certificates. ClearPass shows the following error.

What is needed to resolve this issue?

Enable authorization in your Authentication Method.

Recreate the SSID m tunneled mode.

Modify your ACX-AD authentication source to include the UPN in the search.

Configure ClearPass to trust the client certificate.

NEW QUESTION 61
A university owns a campus with several buildings segmented into east and west wings, which are L3 separated. The east wing has 1600 APs. and the west wing has 1200 Aps. Each wing has a single gateway cluster managed by HPE Aruba Networking Central. Each cluster contains one 7210 mobility gateway The gateways are configured with DHCP relay and route all client VLANs. A new business-critical facultyreal-time application requires users to roam within wings but not across wings without disconnections or delay increments.
Which changes must the network administrator make lo successfully meet the requirement without performance degradation matching best practices? (Select two.)

Replace the 7210 mobility gateway in the west wing with a pair of 7030 mobility gateways.

Add a single 7210 mobility gateway to each cluster.

Remove the DHCP relay from the gateways and enable the DHCP server instead

Replace me 7210 mobility gateway in the east wing with a pair or 9012 mobility gateways

Run L2 for all SSIDs and permit the users’ VLANs in the gateway’s uplinks.

NEW QUESTION 62
A network technician racked up two 9240 mobility gateways in a single cluster that will be terminating 1700 APs in a medium-sized branch office Next, the technician cabled the gateways with two SFP28 Direct Attach Copper (DAC) cables, distributed between a two-member core switching stack and powered them up.
What must the network administrator do next regarding the gateway configuration to ensure maximum wired bandwidth utilization?

Map two physical ports to a port channel on each gateway.

Make an ports trunk interfaces and permit data VLANs

Disable the spanning tree and allocate unique VLANs to each port.

Manually set 25Gbps speeds on all ports.

NEW QUESTION 63
Exhibit.

You updated your gateway to me most recent firmware However after the firmware was updated, the gateway could no longer connect to HPE Aruba Networking Central. Your corporate ITIL procedures require you to implement your backout plan. You connected a console cable to your gateway and saw the following prompt.
Cpxload#
in what order, do you need to execute the following commands to return to the previous firmware version?