Q35. You enable the Multiple VLAN Registration Protocol (MVRP) to automate the creation and management of virtual LANs.
Which statement is correct in this scenario?

Q36. Which two statements are correct about the deployment of EVPN-VXLAN on QFX Series devices? (Choose two.)

Q37. You have PIM SM multicast configure and running in a network environment comprised of EX4300 devices. Your customer report increased delay when switching channels using IPTV. To help decrease the delay, you implement PIM join balancing. You add the set protocol pim join- load-balance command to the configuration. After committing, you notice that the flows are still using one path.
In this scenario, which statement is correct?

Q38. Referring to the exhibit, a PIM-SM network is set up to enable communication between multicast devices.
Which two statements are true? (Choose two.)

Q39. Your network has an unmanaged switch between the hosts and your EX Series switch. After the traffic enters the EX Series switch, each host must be on a separate VLAN.
How would you accomplish this task?

Q40. What is a supplicant in 802.1x authentication?

Q41. You want to provide Layer 2 connectivity between campus sites using Ethernet switches through a metro Ethernet service provider who is using Q-in-Q tagging on their network.
Referring to the exhibit, what are two design considerations in this environment? (Choose two.)

Q42. Which address range is used for source-specific multicast?

Q43. Which two authentication methods are available for OSPF on Juniper devices? (Choose two.)

Q44. A modified deficit round-robin scheduler is defined by which three variables? (Choose three.)

Q45. You are troubleshooting an OSPF adjacency issue between R1 and R2.

What is the reason for the ExStart state shown in the exhibit?

Q46. You are asked to configure 802.1X on your access ports to allow only a single device to authenticate.
In this scenario, which configuration would you use?

Q47. Click the Exhibit.


You have just configured on an OSPF adjacency between two routers. After you commit the configuration, you notice that your adjacency is not up.
Referring to the exhibit, what would cause the problem?

Q48. Referring to the exhibit, which two statements are correct? (Choose two.)

Q49. A Layer 2 connection does not expend across data centers. The IP subnet in a Layer 2 domain is confined within a single data center.
Which EVPN route type is used to communicate prefixes between the data centers?

Q50. There are two BGP routes to 10.200.200.0/24 received from two external peers. Route 1 comes from a neighbor with a router ID of 10.10.100.1 and a peer IP address of 10.10.30.1, and route 2 comes from a neighbor with a router ID of 10.10.200.1 and a peer IP address of 10.10.50.1. Both routes have the same MED value, origin value, AS path length, and local preference number. In this scenario, which statement is correct about the active route?

Q51. Which two port modes are associated with STP? (Choose two.)

Q52. Which BGP message type contains NLRI information?

Q53. Referring to the exhibit, how is R1 learning the route from R2?

Q54. You are troubleshooting a route problem in the topology shown in the exhibit. The 10.30.0 0/24 route is not reachable from the R3 router. What would cause this problem?

Q55. Which two statements are correct about the deployment of EVPN-VXLAN on QFX Series devices? (Choose two.)

Q56. You are implementing the route summarization feature of OSPF. Which two results do you achieve in this scenario? (Choose two.)