[Q19-Q37] NS0-093 PDF Download Jan-2025 Network Appliance Test To Gain Brilliante Result!

4/5 - (1 vote)

NS0-093 PDF Download Jan-2025 Network Appliance Test To Gain Brilliante Result!

Provide Updated Network Appliance NS0-093 Dumps as Practice Test and PDF

As the demand for professionals with experience in managing enterprise storage infrastructure continues to rise, obtaining a NS0-093 certification becomes more important than ever. NetApp Accredited Hardware Support Engineer certification provides an opportunity to demonstrate one’s expertise in supporting NetApp systems and to become more competitive in the job market. It also assures employers that they are hiring professionals with a consistent and high level of knowledge regarding NetApp systems.

NEW QUESTION 19
You have upgraded your cluster from ONTAP 9.5 software to ONTAP 9.7 software. After the upgrade, you notice that the upgrade causes issues. You decide to revert to ONTAP 9.5 software.
Which revert step is allowed?

Revert to ONTAP 9.5 software with the netboot procedure.

Revert from ONTAP 9.7 software to ONTAP 9.5 software by using the boot backup procedure.

Revert directly from ONTAP 9.7 software to ONTAP 9.5 software.

Revert from ONTAP 9.7 software to ONTAP 8.6 software and then to ONTAP 9.5 software.

NEW QUESTION 20
A SAS connection is reporting a single PHY down.
What are the two most likely causes? (Choose two.)

improperly seated cable

outdated I/O module (IOM1 firmware

defective cable

an offline shelf in the stack

NEW QUESTION 21
In a SAS stack of shelves, what is the topology of the connection between expander and disk?

arbritrated loop

point-to-point

loop

ring

NEW QUESTION 22
In maintenance mode, which of the following commands shows disk ownership?

sysconfig -v

disk show -v

aggr status

storage show disk -p

NEW QUESTION 23
Where is a kernel core file stored on a FAS9000 system that is running ONTAP 9.12.1 software?

on the partner root aggregate

on the root aggregate

on the mailbox disk

on the boot device

NEW QUESTION 24
What is the default amount of time that a volume is available for recovery from the volume recovery queue following a volume deletion?

12 hours

48 hours

72 hours

24 hours

NEW QUESTION 25
You have identified that the file named quarterly_25.docx is inconsistent.
Which nodeshell command reports whether there are Snapshot copies available?

“priv set advanced; file check -f quarterly_25.docx”

“priv set diag; file check -v <voiname> -i <field>”

“priv set diag; snap list -f quarterly_25.docx”

“priv set advanced; aggr wafliron start -f quarterly_25.docx”

NEW QUESTION 26
During which two operations is the NVRAM replayed by the high-availability (HA) partner? (Choose two.)

after triggering a sync core

when a node is halted

during a negotiated takeover

when the node loses power

NEW QUESTION 27
A node has panicked with a PCI/NMI error. Giveback has not been performed.
Which two commands should you run to collect the logs to determine the cause? (Choose two.)

pelog -a -g=2

show pci -v

rdfile /mroot/etc/log/SSRAM

event log show

NEW QUESTION 28
You are replacing a boot device on a FAS8300 system that is running ONTAP 9.10P6 software. You attach a USB memory stick to the external USB port on the storage controller but cannot access the memory stick.
What step needs to be performed to access the boot device?

Set the port to “enabled” with setenv.

You need to use ONTAP 9.11 or later software.

Add the boot device before the BIOS is loaded.

The external USB port is not activated on NetApp systems.

NEW QUESTION 29
When you add a new disk to an ONTAP 9.1 system, you see an error that the disk “has raid label with version (16), which is not within the currently supported range (14-15).” What is one possible cause of this error?

The disk is a non-zeroed spare.

The disk firmware is too new for ONTAP software.

The disk needs to be assigned to the new system.

The disk was in a system with a newer version of ONTAP software

NEW QUESTION 30
On a NetApp FAS9000 system, which two field replaceable units (FRUs) are supported for replacement without takeover? (Choose two.)

I/O module

DCPM module

caching module

NVRAM module

NEW QUESTION 31
Which two steps are required to replace a drawer in a DS460c shelf? (Choose two.)

Shut down both nodes.

Disconnect the cable chains from the chassis.

Power off the shelf.

Evacuate all drives in the drawer.

NEW QUESTION 32
An aggregate has experienced a multiple disk failure due to a failing I/O module (IOM). The module has been replaced and the aggregate is still failed.
What step can be taken to recover the aggregate?

Use diskcopy from maintenance mode.

Run wafliron from the boot_menu.

Unfail the drives from maintenance mode.

Unfail the drives in the order that they failed from the clustershell

NEW QUESTION 33
What are two valid options for uploading a core file from a node that is running ONTAP 9.12.1 software to NetApp for analysis? (Choose two.)

system node autosupport invoke -diagnostic

Download via CIFS and upload to upload.netapp.com.

Download via Service Processor Infrastructure (SPI) and upload to upload.netapp.com.

system node autosupport invoke-core-upload

NEW QUESTION 34
You have replaced a failed boot device. You perform boot_recovery and receive no errors. However, when the node reboots, it reports that it has no disks.
What are two possible causes? (Choose two.)

The SAS cables were incorrectly reconnected after reinstalling the motherboard.

The disks that are owned by this node have been marked as failed.

The node is booting a lower version of ONTAP software than was last used.

The interconnect is down.

NEW QUESTION 35
On an AFF A700 system, a SAS stack is connected to SAS ports 2a and 2b. The system has an additional 4- port SAS card in slot 9.
How should the cabling the corrected for best practices?

Use port 2a and 9a.

Use port 2b and 9d.

Use port 2a and 9b.

Use port 2a and 2c.

NEW QUESTION 36
Following an unexpected takeover, the taken-over node is waiting for giveback. The administrator plans to perform a giveback with the option -cfo-only true.
What happens if this option is used?

Only a simulation of the giveback is performed.

Only the root aggregate is given back.

Only SVM root volumes are sent back

Only the data aggregates are sent back.

NEW QUESTION 37
You have created a case with NetApp Support for an issue with a DS4246 shelf on an ONTAP 9.12.1 system.
They have requested that you provide shelf logs.
What action do you need to take to collect the shelf logs?

Provide the output of the nodeshell command rdfile/etc/log/shelflog.

Invoke an autosupport of type all using Active IQ Unified Manager.

Invoke a diagnostic AutoSupport with the subsystem storage.

Invoke a diagnostic autosupport with the subsystem log_files.

Network Appliance NS0-093 certification exam validates your ability to install, configure and administer NetApp hardware, identify hardware faults and troubleshoot them, and communicate effectively with technical support teams. Achieving this certification will demonstrate your expertise in the latest industry-standard technologies that NetApp hardware support engineers use every day. Upon successful completion of the exam, you will receive a NetApp Accredited Hardware Support Engineer certification, which is a valuable credential in the industry.

NS0-093 Dumps are Available for Instant Access: https://www.braindumpsit.com/NS0-093_real-exam.html